3.3.3 Standard views

The following views are available as standard views.

• I: Inside
• A: Exterior
• O: Top
• U: Bottom
• V: Front
• H: Rear

By clicking on one of these buttons, you can always display the moulding in one of these views. If you position a bar manually on the workspace (rotate), you may leave the standard view. In this case, the button is also deactivated again.

Attention:        If you want to measure the lengths, a standard view must be activated (I, A, O, U, V or H). If you want to display the current lengths, you must be in one of the views I, A, O or U.