4.6 Switching on the printer
| 1 | Connect the supplied IEC AC cable to the plug on the back of the printer.
Connect the other end of the cable to the socket with earthing connection.
IMPORTANT: The red switch must be in the 0 position (OFF) when the mains cable is installed. |
|
2 |
Switch on the mains switch on the rear panel.
This switch controls: 1. internal power supply 2. power supply to the filament chamber
|
|
3 |
Use the ON/OFF button on the front to get the printer out of stand-by mode.
Note: In stand-by mode, power is only supplied to the filament chamber and the internal power supply unit. All other parts of the printer are OFF. |
