| 1 | Place the ramp on the prepared fixing holes. |  |
| 2 | Tighten the ramp with the four screws provided in the accessory bag. |   |
| 3 | Check that the ramp does not hinder the free movement of the print bed. To do this, use the button Z below in the option Manual control on the LCD screen. Using the screws that hold the main part of the ramp, you can adjust its position if necessary so that there is a gap of 3-4 mm between the edge of the ramp and the print bed. |   |
A camera is used to automatically start a print, which checks whether the object has been correctly removed from the printer and ensures that the print bed is free for the next print. Carry out the following steps to install this camera.
| 1 | Remove the 2 screws located on the left side of the top printer frame. |  |
| 2 | Take the camera mount and the power supply unit. Place the power supply cable in the channel of the holder so that the power socket protrudes 6-7 cm. |  |
| 3 | Place the bracket on the left side of the upper printer frame, align the bracket with the holes of the removed screws and reinsert the fixing screws. When properly installed, the camera's power supply cable is concealed under the bracket. |  |
| 4 | Position the camera in the recess provided in the holder. |  |
| 5 | Connect the power cable to the camera. |  |
| 1 | Open the chamber and locate the cable inside. |   |
| 2 | Lay the cable out to the front and connect it to the sensor. |   |
| 3 | Insert the sensor into the slot and pull it downwards. |  |
| 1 | Locate the 2 fixing holes for the print head cable holder on the back of the printer. |  |
2 | Attach the bracket and tighten the screws using the 3 mm Allen key supplied. |  |
The filament chamber serves as a place to keep the filament used by the printer ready and at the same time to keep the condition of the filament stable.
When the filament chamber is supplied with power, a red light in the chamber switches on.
WARNINGIf the power supply is disconnected (power button on the back (OFF/0) or the cable has been removed), make sure that the filament is removed from the filament chamber and stored in a dry and warm (min. room temperature) environment.
Connect the 4-pin plug to the filament chamber and screw it tight. Connect the other end of the cable to the printer in the same way.
IMPORTANT: The filament chamber is always switched on when the main power switch is switched on. This ensures the correct environment for the filament in the chamber, even when the printer is in stand-by mode. Before switching off the filament chamber, please make sure that you have stored the filament in another location with controlled temperature and humidity.
To install the filament chamber on the printer, turn the printer so that you have access to the rear of the printer:
1 | Remove the three screws from the filament chamber on the back of the printer and loosen them about 2 mm from the printer disc using the 3 mm Allen key supplied. |  |
2 | Slide the filament chamber onto the three screws and tighten them. |  |
To avoid damage during the last part of the printer installation, the printer must be completely switched off.
| 1 | Switch off the printer. |  |
| 2 | Switch off the mains power switch. |  |
| 3 | Disconnect the mains cable. |
To remove the large box from the printer, the print bed must be lifted.
This is done via the menu Manual control:
| 1 | Open the menu Manual control (1). |  |
| 2 | Hold the button Z top (1) to move the print bed all the way up (when it reaches the limit, the print bed will stop moving). Note: You can safely switch off the printer in this menu. |  |