Measurement and signal tone

After selecting the menu item "Measurement", the following operating states can be selected using the ¬ or ® buttons:

Press the button:	The data logger starts a measurement after pressing the button start/centre and stores the data on the memory card. Press again to pause the measurement and an entry is made in the memory card directory.
expect triggers:	Press the button start/centre causes the radio release to be ready. The message "***ready***" appears. Start or pause is triggered by pressing a button on the transmitter. To cancel, press the button off on the data logger.
Monitor:	By pressing the button start/centre the data is measured and output via the serial interface, but only when the power supply unit is connected. This operating mode is useful for test purposes. The numerical range of the values covers the range 0..1023. Values above 1000 cause the signalling of overload.
Signal tone:	Press the button start/centre allows you to switch the signal tone on/off using the ← , → buttons. The buttons save, start/centre or ↑ lead to an exit from this command. Switching the acoustic signal on/off only refers to the acoustic indication of the start and stop of a measurement. The acoustic signal can still be heard when the device is switched on/off.

The active measurement status is indicated by the message "Measurement running", an interruption by "Break" displayed.

From version 3.01, a measurement can be triggered by radio directly after switching on without having to access the corresponding submenu via buttons.