Standard views

The following views are available as standard views (see Figure 11).

• I: Inside
• A: Exterior
• O: Top
• U: Bottom
• V: Front
• H: Rear

By clicking on one of these buttons, you can always display the insert in one of these views. If you position an insert manually on the workspace (rotate, rotate), you may leave the standard view. In this case, the button is also deactivated again.

Attention:        If you want to carry out a measurement (see 3.2.4), a standard view must be activated (I, A, O, U, V or H).
If you want to display the current lengths (see 3.3.6 Lengths), you must be in one of the I, A, O or U views.