The milling machine cannot be switched on

B
The milling machine cannot be switched on

The limit switch is activated.

  1. Move all axes of the table from the end position. If the door is open, this can be done manually.
    With the door closed, open "Control" -> "Options" -> "Move limit switch freely" in the remote programme. The message "Please switch on the amplifier" then appears, please switch on the amplifier before clicking on "OK".
  2. Please clean the interior of the milling machine afterwards

The safety module (ISM 10) is defective

  1. The module is located next to the computer and can be replaced. Please contact GeBioM support, who will replace the module's fuse or, if the module is defective, the entire module.