My milling machine has milled into the table
If the milling machine mills into the table, this can have the following causes:
The zero point in the GP Manager is set incorrectly
After you have changed the milling head, you must reset the zero point. Please watch our support video "Changing the milling head". You must set the correct zero point in the GP Manager as shown in the video.
Changing the milling cutter and setting the zero point for GP M101/102/202
Changing the milling cutter and setting the zero point for GP M302
The milling head sits loosely
Please check the milling head and fasten it correctly.
The milling head is not inserted correctly
Please ensure that the milling head has been inserted correctly. The milling head must protrude 1 cm from the housing.
Only for milling machine 101 (old milling machine)
Replace the motor of the axles