To compare two measurements with each other, you must first select a data set for comparison. To do this, click on the button 
- This is located to the right of 
.
You can select a comparison measurement in the following preview window:
Select a comparison measurement by clicking on it. Now confirm this selection with the OK button.
To see the selected comparison, you must tick the checkbox 
before the comparison.
If you deactivate the control box, you will return to the initial measurement.
| Create customer - Button "NEW"; or call up old customers - button "Determine„ | ||
| Menu "Trade fairs" select | ||
| The following window is displayed
Important: |
||
| Switch on the transmitter "from„ | ||
| Button "Measurement" click | ||
| The following window is displayed | Check whether the correct soles are connected | |
| Now switch on the transmitter "a„ | ||
| In the following window permanently measured online. |
Important: The soles must be connected before switching on the transmitter, otherwise the correct calibration files will not be recognised. |
|
| Button "Accept measurement" Click here | ||
| Button "Start measurement" click | After clicking the "Start measurement" button, a measurement is recorded until the "Accept measurement" button is clicked. | |
| The measurement is accepted and displayed |
[wpfilebase tag=browser id=129 /]
| Sequence | Illustration | Remark |
|---|---|---|
| Insert the SRAM card into the OmniDrive | ||
| Select GP MobilData in the Measure menu | ||
| Click on measurement |  |
|
|
 |
|
| Evaluate measurement |
With a click on "Save" to save the new settings. If you want to discard the changes, click on the crossed rectangle CloseCross.bmp at the top right of the dialogue box.
In the "Units" button to select the units of pressure (mbar, N/cm², kPa or mmHg).
Note:
The displayed list also contains the units for the impulse [Ns] and [mNs]. Make sure that these units are not selected for the pressure.
If the checkbox "Autoscaling" checkbox, the scaling is set to the maximum value. If the checkbox is deactivated, the scaling is set to the last set value.
With the button "font" you can change the colour of the text in the legend. This is done after clicking on the item "Colours" was described.
With the button "font" button to change the colour of the text in the legend. This is done by clicking on it as described under "Colours".
With the function "Calculate", a colour transition scale is created, i.e. after creating a start and end colour, the intermediate colours are calculated and entered by the program. To do this, define the start and end colour as described in "Colours" colour. Then click first on the start colour and then on the end colour while holding down the Ctrl key. When the start and end colour squares are marked with a box, click on the "Calculate". The intermediate colours are now calculated automatically.