Einlagenberechnung

The top drop-down menu provides a selection of how the insert is adapted to the selected measurement. GP InsoleCAD offers several options for how this is calculated. By default, the two options Measurement (length, width, height) and Original size are activated. These two methods are sufficient for most cases. The other methods can also be activated on request.

Measurement (length, width, height)

The inlay is adapted to the measurement in width and length. The corresponding height is taken from the grading table.

Original size

The model of the insert is loaded from the library in the size in which it was saved there.

Note: Which options are available in the drop-down menu depends on the settings of the GP Manager installation. The following additional options are possible and can be activated on request. As a rule, however, these are not required.

Best possible size (stitch)

The insole is adapted to the measurement in width and height according to the grading table. The next larger "shoe size" is used for the length of the measurement (plus toe allowance).

Specified size GP FootMeasure

Manual adjustment of the customer's actual size. To be set by the person scanning/measuring the customer. The measured values are stored in the GP FussMess module and can only be entered in GP InsoleCAD be utilised.

Measurement (length, ball, heel)

Predefined points at which a fixed value of millimetres is added to the insert.
- (tip/end)
- (Bale inside/bale outside)
- (inside heel, outside heel)

The points are displayed in the GP FussMess module and can only be set in the GP InsoleCAD be utilised.

Adopt only the form

Existing models (pads, bars, etc.) are retained, only the inlay is exchanged with the selected inlay from the library.

Measurement (length, width)

Subsequently changes the size of the insole and all models (length/width) without changing the height, i.e. if this option is not activated, changing the shoe size also grades the models.