Before replacing the output stage, set the appropriate address for the output stages. The position of the switches for the two axes can be seen in the pictures below.

In case you are interested: The address is entered via the DIP switches in the binary system (switches 1-5 correspond to 2⁰ to 2⁴, in the example below this results in 1*2⁰ + 1*2⁴ = 17).

Figure 1: Assignment of the DIP switches

DIP switch position for the X-axis (address: 1):

Figure 2: DIP circuit for address 1

DIP switch position for the Y-axis (address: 2):

Figure 3: DIP circuit for address 2

Data specific to the milling machine is stored on the output stage. This data may need to be transferred between the old and new output stage. If you are not sure whether this is necessary, please ask GeBioM mbH Support.

If you have set the DIP switches correctly and the data has been transferred, you can swap the output stages in the control cabinet 1 to 1.

After replacing the output stages, start the milling computer.

• Select "Start" -> "Programmes" -> "AC Setup C269" (sometimes also ISEL Germany AG) -> "ACSETUP C269„
• At the top of the menu, select "File" -> "Open" -> mostly D:\Backup\cncWorkbench...\Control\CAN\DCF-Files to select the relevant DCF file.
• Now go to Connection -> CAN settings

Figure 4: Menu for the CAN settings

• In the following menu, pay attention to the correct CAN node indicate!
  • 1 for X-axis
  • 2 for Y-axis
• Select the DLL for CAN communication: C:\CNCWorkbench\Control\CAN\CAN_API.dll
• Confirm with OK

Figure 5: CAN configuration for X-axis (address: 1)

• Select "Connection" -> "Online mode" (or click on the satellite dish).

Figure 6: Online mode

• Select the PC to card option in the following dialogue.

Figure 7: PC to card option

• If no message appears, you can exit online mode and close the programme. The question about saving is answered in the negative.