Edge processing

There are two ways to edit the edge of the insert. Either use the input fields with height values (in mm) to edit the edge or use the option to edit the edge with the mouse.

Editing the border with the height values

You can model the edge of the insole higher/lower by changing the height values in the input fields. Please note that you do not use the input field for the toe bridge (see Figure 22).

Note:  When modelling the heel cup, it generally makes sense to edit the four rear values (marked in green). The easiest way to do this is to select the top left-hand value and enter the desired height using the keyboard. Use the Tab key to jump to the next field. Once you have changed the heights, press the Enter key and the new margin will be calculated.

You can also change the values using the arrow buttons, in which case changes to the border are calculated immediately

Key combinationAmendment
Figures	Enter the new edge height
Tab key	Next input field
Shift + Tab key	previous input field
Enter button	Adopting the changed edge heights

Editing with the "Border editing" selection box

If you activate this option, you can use the standard views "I" and "A" to model the border with the mouse. To do this, click with Ctrl + left mouse button on one of the border points (coloured squares) and drag the border to the desired height.

Attention: To be able to use this option, you must be in the "Insert" (see 3.5.3.1 Insert / measurement).