My milling machine has milled into the table

If the milling machine is milling into the table, this could have the following reasons:

Wrong zero point set in the GP Manager

After changing the cutter, you need to check the zero point. Please have a look at our support video „changing milling tool“. You need to fill in the correct zero point in the GP Manager as shown in the video.

The milling tool is not tight

Please put it in tight

The milling tool is not inserted completely into the holding

Please make sure, that the milling tool is put correctly into the holding. The milling tool has to look 1 cm out of the exhausting preparation.

Only applicable for milling machines of the type GP M101 (old machines)

Changing the motors of the axes.