Fix the sender to the body by using the carrying strap. Afterwards connect the measurement areas with the appropriate cables. The receiver is connected with the USB cable to the USB hub (USB 2.0 is required).
- 1 Radio Sender
- 1 Radio Receiver for USB 2.0
optional
- Measurements areas insoles (5 pairs)
- Measurement areas glove
- USB cable
- 2 connection cables
- Carrying strap
- Leg straps
Sender
| Description: | Battery driven radio sender with built-in antenna |
| Radio Range: | 2.4 GHz 500kbps Wireless Data Transceiver (IKM 2.4 A) tested and certified according to the R&TTE-Directive; 100 m in the open air, 15 m inside buildings |
| Data Transmission: | Max. 200 frames/s |
| Number of Channels: | 5 |
| Resolution: | 12 bit |
| Connection: | Max. 2 Senor-Array-Adapters; RJ-45 (as described below) |
| Size: | 150 mm x 100 mm x 43 mm; 200 gr |
| Batteries: | 4 Mignon accumulator batteries (AA); 1.5 V |
| Reproducibility: | +/- 5% |
Receiver
| Description: | Bluetooth-stick for the device described above (class 1), range of 100m |
| Connection / Port: | USB 2.0 |
| Frequency: | 2.4 GHz |
| Size: | Different – see producer |
Sensor-Array-Adapter
| Description: | Multiplex for a 8×8 matrix of FSR-Sensors |
| Connection: | RJ-45 |
- First install the software from the provided CD. This is necessary, since the CD contains all drivers for the hardware components in a packed format. Those can only be used from the hard drive after installation. Insert the CD into your CDROM drive. The installation commences automatically. Please now follow the installation instructions.
- Following the installation, the receiver is connected to the PC’s USB hub (necessarily USB 2.0) using the provided USB-cable.
- The operating system recognizes the receiver as new device and Window’s hardware installation assistant starts.
- Please choose the point „Install software from a list or a specific source…“ in the first box. Then click on „continue„
- In the following box please choose the option „search this source for the fitting driver“ and select the control box „also search the following sources„.
- Confirm or continue through the following dialogue boxes.
- In the final box the driver is now indicated as „Cesys CeUsb2 (unconfigured)“.
ATTENTION:
The installation is not yet finished The device is still „unconfigured“. - After clicking on „complete“ MobilData is again recognized and the driver installation is completed. Here, the steps 3 to 7 are re-run and when the installation is completed the driver is indicated as „Cesys CeUsb2„.
- After clicking on „complete“ the installation is completed and GP MobilData Radio is ready for use.
Fix the sender to the body by using the carrying strap. Afterwards connect the measurement areas with the appropriate cables. The receiver is connected with the USB cable to the USB hub (USB 2.0 is required).
- 1 Bluetooth Sender
- Bluetooth Receiver for USB 2.0
optional
- Measurements areas insoles (5 pairs)
- Measurement areas glove
- USB cable
- 2 connection cables
- Carrying strap
- Leg straps
In this section the hardware is described. As the hardware has evolved over time the features of the differend versions are described to distinguish between the measuring systems.
GeBioM recommends a regular calibration of the measurements films and sensors by the manufacturer at least once a year. If the systems are used on a nearly daily basis, this procedure should be repeated more often. In the industry this can also be carried out by an appropriately equipped and instructed laboratory. The special calibrating procedure necessitates an instruction through the manufacturer.